SIX
SEVEN
15
16
The decal supplied is for an authentic I-H Eagle paint scheme. Also,
additional decals are supplied if you do not choose to build your
model with this paint scheme.
Cut out your decal next to the paint edge, trim out all areas indicated
on the drawing. Soak your decals in room temperature water for a few
seconds then apply to the hood, cab, and assembled sleeper BEFORE
trim is put on. Note: if you are painting the body of your model, make
sure the paint is fully dry before applying decals.
91CR
113CR
112CR
109CR
110CR
120A
frame
end view
120
108CR
91CR
107CR
112CR
113CR
121
121A
Right Side
of Frame
TRIM CLEAR FILM
TRIM
CUT
CUT
CUT
CUT
The sleeper decals should be
cut at the door line after they
are applied.
Assemble the fuel tank on the right of the frame
as shown ablove, working around exaust stack.
DECALING INSTRUCTIONS:
Scrape plating from glue joints.
For ease of decal handling, particularly the stripes going around the
grille opening and around the front fenders, some modelers may wish
to cut these into several sections before application. The front stripe
may be cut at the upper corners and the L and R stripes at the junction
of the wheel well opening and the longer straight section. After decals
are in position, blot carefully with a wadded tissue to remove excess
water - let dry thoroughly before handling.
NOTE:
1/4
3/8
17
18
19
22
20
23
21
Cement windows in place from inside
of cab. Work very neatly using just
enough cement to do the job.
Cement C.B. radio and mike plus steering
wheel to instrument panel as shown.
Center and glue header – 159 –
in place. Center and glue back
wall – 156 – to rear inside
wall of cab.
Center and glue instrument panel
in place butting the top of the
panel to the bottom edge of the
windshield glass – see side view.
Insert sidewalls – 140 & 141 –
into place and push down as
far as they will go. Cement into
place.
Glue tunnel or “doghouse”
– 157 – into place.
Insert floor unit into place inside cab. Be sure floor is even
with bottom edge of cab. Now cement.
Assemble cab floor interior pieces as shown.
Assemble the right side inner
panel as shown. When finished,
do the left panel - 140 - in the
same way.
3aCL
2CL
3bCL
CAB
44
35
151
136
119CR
81CR
80CR
99CR
141
25
46 (2)
155
83CR
68
135
151
159
140
141
CAB
CAB
Floor
even
with bottom.
157
156
side
view
24
82CR
(see page 10 for
color detail.)
1CL
3cCL
Delete rear window
if sleeper is used.
If you plan on
painting the inside,
paint interior pieces
before they are
glued into place.
Apply decal around grille opening first, then onto
bottom edges of fenders, aligning overlap.
Decal Option
