1
Uncrating/Installation Instructions
122993-618
The following is a summary of the safety precautions which must be observed when uncrating, installing and
operating this equipment. WARNINGS indicate the potential for danger to personnel and CAUTIONS indicate the
potential for damage to equipment. These precautions are repeated (in whole or in part), where applicable,
throughout the instructions.
WARNING - PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD:
When moving the unit, use a forklift. Do not use door(s) or door handle(s) for lifting.
WARNING - LACERATION/EYE INJURY HAZARD:
When removing bands, wear eye protection and always use a tool specifically designed to cut the bands.
The bands used to secure this carton can cause personal injury when cut and tension is released.
WARNING - LACERATION HAZARD:
When removing bolts, wear gloves to protect your hands.
WARNING - BURN HAZARD:
When checking the automatic stop feature, wear gloves and face protection and open chamber door slowly.
Hot water/steam may be sprayed through door opening if door is opened during a cycle.
When blowing out utility supply lines, wear gloves, face shield and protective clothing.
WARNING - PERSONAL INJURY HAZARD:
When closing chamber door, use door handle. Keep fingers/hands away from top and sides of door to prevent
fingers from being crushed.
WARNING - FALL HAZARD:
To prevent falls, keep floors dry. Promptly clean up any spills or drippage.
CAUTION - POSSIBLE EQUIPMENT DAMAGE:
After utilities are connected to washer, slowly remove the protective adhesive paper from the exterior
cabinet panels to reduce the level of static discharge.
When removing adhesives from stainless steel, use a small amount of non-flammable cleaning solvent.
Rub in a back-and-forth motion (in same direction as surface grain). Solvent rubbed in a circular motion
or applied with a wire brush or steel wool on door and chamber assemblies can be harmful to stainless steel.
Do not use solvents on painted surfaces.
Once three-phase power is connected, check pump for correct rotation. Incorrect pump rotation may result
in pump damage and improper cleaning action.
Before operating unit, always position each manifold over a manifold connector. If manifolds are not
positioned correctly, damage may result and unit will be unable to effectively wash loads.
1
SUMMARY OF WARNINGS AND CAUTIONS
Summary of Warnings and Cautions
