Amsco 36 H, Operator'S Manual

Page: 39 / 152

5-7
Component Identification Operator Manual P129394-068
5.6 Cycle Selection
Touch-screen Pads
Four cycle selection touch pads are shown on the screen in
Figure 5-7 . These pads display the basic parameters of the cycle
• Cycle name
• Sterilization exposure temperature
• Sterilization exposure time
• Dry time
Additional cycles may be selected by pressing MORE CYCLES.
Details on individual cycles are in
S
ECTION
6, S
TERILIZER
O
PERATION
.
AMSCO 400 Series Medium Steam Sterilizer control can be
programmed to retain values for up to 12 separate cycles. User-
defined cycle names can be entered for cycles 1 and 2 on the cycle
selection screen.
The first six cycles (1 through 6) are the factory default cycles and
are routinely displayed on screen #1 (press MORE CYCLES to
access cycles 5 and 6). Up to six additional cycles can be
programmed and displayed.
Important: Applicable cycles have been validated to satisfy the
requirements outlined in Table 1 (page ii). If cycle parameters
(sterilize time, dry time, temperature) other than those listed are
required, it is the responsibility of the healthcare facility to follow the
device manufacturer’s written instructions.
Dart
®
(Bowie-Dick) and Leak Test cycle parameters are fixed; the
buttons for these cycles do not display values for exposure
temperature, exposure time or drying time.
Figure 5-7. Cycle Selection Touch Pads
STATUS . . DOOR CLOSED 1
TEMP . . . 128 F
PRESS . . 0 PSIG
PRESS "MORE CYCLES" FOR GRAVITY & TEST.
1.270 ° F 2.275 ° F 3.270 ° F 4.270 ° F
PREVAC PREVAC PREVAC PREVAC
S=04 D=30 S=03 D=30 S=04 D=20 S=04 D=05
FULL LOAD FULL LOAD FULL LOAD SINGLE
TRAY TRAY FABRIC FABRIC
10:20:34 AM 10/08/10
STANDBY MENU
PAPER
FEED
MORE
CYCLES
DOOR
OPEN
DOOR
CLOSE
Press one of these
buttons to start a
cycle
Press this button
to access MORE
CYCLES