AMERICAN MINE RESEARCH, INC.
MODELS LS-3030
BELT SLIP/SEQUENCE AND CONTROL
INSTALLATION AND SETUP
INSTRUCTIONS
P/N 180-0361
P. O. Box 234 Rocky Gap, VA 24366 540-928-1712 Fax 540-928-1814
E - Mail
[email protected]
Page 1: ...RICAN MINE RESEARCH INC MODELS LS 3030 BELT SLIP SEQUENCE AND CONTROL INSTALLATION AND SETUP INSTRUCTIONS P N 180 0361 P O Box 234 Rocky Gap VA 24366 540 928 1712 Fax 540 928 1814 E Mail amrinc inetone net ...
Page 2: ...um distance is 1 4 An indication light is built into the rear of the module in order to check proper positioning and operation Note Little Speedy should be mounted between 1 8 and 3 8 from a moving target The movement of the target across the magnetic field of the sensor will reflect the speed of the target you are monitoring For example if mounted on the tail pulley of a conveyor belt as the spok...
Page 3: ... further assistance in using this feature SPAN LED ZERO Step 5 Now that the LS 3030 has been mounted it can be calibrated Connect the Multimeter in line with the neutral and set the meter to read mA With the belt off the multimeter should read 4 mA on the output If not locate the zero potentiometer Using screwdriver rotate the pot counterclockwise till the multimeter reads 4 mA Now that the Zero C...
Page 4: ...or the off condition 7 Now measure the movement the Belt or Device move per minute in it s normal running condition Type that value in Calibrate Gain to Obtain and Select Calibrate Span and press Enter with the Belt or Device operating under the same condition as the measurement was taken 8 Now that the Little Speedy has been calibrated the limits can be set Select Return and press Enter Select Li...