Amptweaker tightboost User Manual Download Page 3

Page: 3 / 4

Battery Door

–

The battery
door is held
closed by a
magnet, and

can be opened
just by pulling
sideways

EFX Loop Switch

–selects Pre(before) or

Post(after) position for the Loop. Usually
Compressors sound best on Pre, while
Delays & Reverbs sound better on Post

LEDs–

light up

the knobs if an
adapter is used

Battery Switch

–

This switch turns
off the battery
when not in use-
not active when

using an adapter

Effects Send & Return

– It

easy to create your own effects
chains using this series loop–
and the added effects track with
the TightBoost

s On/Off Switch

Specs:

• Input impedance:  250K Ohm (effect on)
• Output Impedance:  1K Ohm (effect on)
• Current:  11mA with 9V battery, 20mA with 9V adapter

(adds knob LEDs)

• Housing: 14 Gauge galvanized steel
• Weight: 2 pounds, Dimensions: 3.75”W X 5”D X 2”H
• Adapter: 9VDC adapter w/ 5.5mm X 2.1mm positive

barrel center ground

Summary of Contents for tightboost

Page 1: ...battery door good tone comes from tweaking TM James Brown Amp Engineer Welcome Thanks for purchasing your pedal the first Amptweaker handmade product desigded with consumers advice After the success o...

Page 2: ...Output Jack connect to the next pedal s input or to amp Tight set higher for an aggressive chunky attack lower for thick fatter boost DC Jack use a high quality regulated 9VDC adapter with center pin...

Page 3: ...switch turns off the battery when not in use not active when using an adapter Effects Send Return It s easy to create your own effects chains using this series loop and the added effects track with t...

Page 4: ...pedal in the Effects Loop set to Pre to give more output level to the distortion By using lower Boost and Mid settings the Tight control can be used to tighten up your attack without boosting For the...