P. 3
| Tecshow Alfie Mini Spot 3
English version
Unpacking instructions
Once receiving a fixture, carefully unpack the
carton, check the contents to ensure that all parts
are presented, and have been received in a good
condition. Notify the shipper immediately and
retain packing material for inspection if any parts
appear damaged from shipping or the carton itself
shows, sign of mishandling. Save the carton and all
packing materials. In the event that a fixture must
be returned to the factory, it is important that the
fixture be returned in the original factory box and
packing.
AC Power
To determine the power requirements for a
particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixtures
specifications chart. A fixture listed current
rating is its average current draw under normal
conditions. All fixtures must be directly powered
off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer source voltage matches
the fixtures requirement. Check the fixture or
device carefully to make sure that if a voltage
selection switch exists that it sets to the correct
line voltage you will use.
Warning
Verify that the voltage select switch on your unit
matches the line voltage applied. Damage to your
fixture may result if the line voltage applied does
not match the voltage indicated on the voltage
selector switch. All fixtures must be connected to
circuits with a suitable Earth ground.
2. INTRODUCTION
3. DISPLAY MENU
Menu Button (from left to right) ”menu”, ”up”,
”down”, ”OK”
System Menu When making adjustments press
ENTER to confirm your setup .
MENU
Sub-MENU
Instruction
Addr
A001-A512
DMX Address
CHHY
(X Y)
Pan & Tilt forward moving
(-X Y)
Pan reverse moving, Tilt forward moving
(X -Y)
Pan forward moving, Tilt reverse moving
(-X -Y)
Pan & Tilt reverse moving
SLnd
Sound
Sound Control
SLAVE
Slave Mode
Auto Fast
Auto Fast Running
Auto Low
Auto Slow Running
