Ampro Stylist, Instructions Manual

Page: 4 / 20

4
Instructions for Setting Up, Operating and
Maintaining the Ampro Stylist Projector
S P E C I F I C A T I O N S
1. POWER REQUIREMENTS –
105 to 125 volts alternating or
direct current. Power consumption 1000 watts with 750 watt lamp, 1250 watts
with 1000 watt lamp.
2. PROJECTION LAMP – A 750 watt 25 hour lamp with medium
prefocused base is standard equipment-1000 watt lamp may be used if
desired.
3. EXCITER LAMP –
4 volt, ¾ Ampere (Part No.18460).
4. PHOTOCELL –
CE 25C (Part No.17572).
5. AMPLIFIER TUBES – 1 type 6BH6 (Part No.18495), 1 type
12AX7 (Part No.18497), 3 type 50C5 (Part No.18498).
6. AMPLIFIER FUSE – 1½ Amp. (Part No.18351, box of 5).
7. FILM CAPACITY – 2000 feet (400 ft. reel supplied as standard
equip-ment.)
SETTING UP
1. Place the projector on a projector stand (Ampro No.19496), desk, or table near the end
of the room opposite the screen location. The end of the case on which the two catches
are located should be pointed toward the screen.
2. Open the three catches which hold the top of the case in place and lift off the top of the
case.
3. Uncoil the line cord (1 Fig. 1). Pull outward on the reel arm lock pin (2) and swing the
takeup reel arm (3) downward into position. If reels having a capacity of less than 800 ft.
are to be used, position the arm so that the lock pin engages the upper hole in the arm.
(See Fig. 1.) If reels having a capacity of 800 ft. or more are to be used, position the arm
so that the pin engages the lower hole in the arm.
A l s o m o v e t h e p r o j e c t o r t o
the front of the stand or tabl e s o t h a t t h e l a r g e r r e e l s w i l l
clear the edge.
Move the belt shifter (4) to the forward position as indicated.
4. Remove the 400 ft. reel and speaker cable (5 Fig. 1) from the clips which hold it in
place inside the top portion of the case.
5. Swing the feed reel arm (6 Fig. 1) to the forward position. Make sure that the rewind
belt (7) is in the groove of the spindle pulley.
6. Connect the line cord plug (8 Fig. 1) to the nearest outlet supplying 105-125 volts AC
or DC current and turn on the "VOLUME CONTROL" (9 Fig. 1).