P. 5
AUDIOLAB ICE-4800
Rear panel
1. Channel 1 XLR Input This XLR input is a
balanced input. Connect this input to the left
output of your mixer.
2. Channel 1 Link Socket This balanced socket
is used to link another amplifier.
3. Channel 2 XLR Input This XLR input is a
balanced input. Connect this input to the left
output of your mixer.
4. Channel 2 Link Socket This balanced socket
is used to link another amplifier.
5. Operation Mode Selector This switch is used
to choose the operating mode of the power
amplifier: Mode stereo: 2 inputs(channel 1
and 2) and 2 outputs are used. Mode parallel:
1 input (channel 1) and 2 outputs are used.
Mode bridge: 1 input(channel 1) and 1 output
are used.
6. Input Sensitivity Selector This selector
allows to choose the input sensitivity: either
1.0V, 1.4V, 2.0V).
7. ON/OFF Switch
If you set this
switch ON, the amplifier adds low- frequen
-
cy compensation so as to enhance speaker
output. The results (the actual change in the
low-frequency balance) will vary according to
the speaker type.
8. Channel 1/3 Turn Lock Output Connect this
turn lock output to a speaker. The branching is
+1,-1(except in bridge mode where the branch
-
ing is +1,+2 ).
9. Channel 2/4 Turn Lock Output Connect this
turn lock output to a speaker. The balance is
+1,-1.
10. AC Cord Plug this cord into the power supply
socket. (Before using the power amplifier,
check if the power supply is 220V).
11. Air Entrance This part is the air entrance.
Don't obstruct it.
