CONTROL PANEL
Electronic Instructions
SW355
Lectern
Your lectern may not contain all of the electronic modules as shown and explained here. Speakers and lectern
microphone are pre
-
wired. To install gooseneck microphone, pull out connector from microphone holder and
snap microphone into connector. Install back into microphone holder.
NEED HELP? Call 800-267-5486
16 CHANNEL WIRELESS RECEIVER
1.
MIC 1
:
Adjusts volume level of gooseneck microphone
on reading table.
2.
MIC 2:
Adjusts volume level of microphone plugged
into the MIC 2 input jack on amplifier.
3.
AUX:
Controls output level of device that is plugged
into the 1/8" jack.
4.
BASS:
This control cuts or boosts the bass level.
5.
TREBLE:
This control cuts or boosts the treble level.
RECEIVER / TRANSMITTER SETUP:
•
The receiver has its own
POWER / VOLUME
Control
(G).
Turn
Power On. A Frequency Channel will appear in the Channel
Display
(A).
Press Select Buttons (
E
) to select a channel. Chan-
nel number must match channel number on wireless transmitter.
•
MUTE LEVEL (F)
is set at half way mark when it leaves the fac-
tory. If speaker sound is breaking up, turn level clockwise with
small screwdriver until condition improves.
•
The transmitter bodypack is operated by 1
-
"AA" 1.5 Volt alka-
line battery. Slide off battery cover
(H)
and install battery as
shown. Make certain the battery is fully seated in its compart-
ment so the cover slides in place easily. Battery life with alkaline
batteries is approximately 8 hours of operating time.
•
Select a channel (1
-
16) on side panel
(I)
using the supplied
screw driver to select channel number. Channel selected
should match channel on receiver. When transmitter and
receiver are set to correct channel the RF indicator
(B)
will
glow red when transmitter is turned on.
•
Plug the Lapel microphone into the Mic Input Jack
(K).
The
microphone can be clipped to a necktie or other clothing,
using the supplied clip. The lapel mic should be placed under
the chin, as close to the center of the body as possible.
•
Slide the power
ON/OFF
switch
(J)
to the
ON
position (the
LED indicator light will illuminate green). Replace batteries
when this LED turns red.
•
GAIN SWITCH (L):
If you are a soft spoken person then set the
switch to the
10 dB
position. If you are a loud speaking person
then set the switch to the
-
10 dB
position. Adjust to prevent dis-
tortion while speaking.
•
Channel Display (A)
•
RF
-
Radio Frequency Indicator (B)
•
AF
-
Audio Frequency Indicator (C)
•
ASC / IR Auto Channel Select (Handheld Only) (D)
•
Select Buttons
-
Manual Channel Selection (E)
•
Mute Level Adjustment (F)
•
Volume Control (G)
A
B
C
D
E
F
G
1
2
3
4
5
Wireless Transmitter
-
Bodypack
Battery Cover
H
Channel Selector
I
Top Panel
J
K
L
Recevier
