5
•
Looking inside of Lectern you will see the backside of the
speaker enclosure. Unwrap speaker wires and bring them to
the front of the amplifier. Plug them into the speaker jacks
marked "L
-
SPEAKER
-
R".
SPEAKERS
Battery Power
1.
The amp uses 10 " D " size Alkaline batteries (not
included); or the optional rechargeable
AmpliVox NiCad Battery Pack (S
-
1465) and
(S1460) AC adapter
, purchase separately (Fig 3).
2. The removable battery door on the back of the
amp is designed to stay closed until you need to
change the batteries. Slip a finger nail under it and
slide it out. (Fig 1)
3. Lift the battery holder out. The plastic dividers be-
tween the batteries help prevent battery
corrosion. (Fig 2)
4. Install
10
fresh Alkaline " D" size batteries. Be
sure to observe the polarity when putting batteries
in the battery compartment. The negative (flat)
ends go against the springs. (Fig 2) Carefully
replace battery holder. Batteries should look like
they are standing up
.
DO NOT MIX BATTERY TYPES OR
ATTEMPT TO RECHARGE ALKALINE
BATTERIES. EQUIPMENT DAMAGE,
SAFETY HAZARD OR FIRE COULD
RESULT.
Note:
The battery holder cable comes from the
factory already plugged into the connector. If
it comes loose, push it in securely. (Turn the
plug over if it doesn’t fit; it only fits one way.)
5. Slide door back into place.
6. If using the
S
-
1465 NiCad Battery Pack
(Fig 3),
replace battery holder with the battery pack. Insert
the battery pack plug into the connector where the
battery holder was plugged into. Plug AC Adapter/
Recharger power supply (S1460) into the
“DC
IN”
jack on front panel of the amp. Plug into a
working electrical outlet. Charge 24 hours for full
charge before using.
Fig 3
Fig 2
Fig 1
S
-
1465
S
-
1460
INSTALL BATTERIES– Model S805A & SW805A
