5
MP3 PLAYER
LED STATUS
Charge Indicator
- will light when main SLA battery is being charged
.
Mode -
will light when SD/USB is being used.
A - B
- will light when programing repeat function.
REC
- will light when recording to a SD/USB device.
Play/Pause
- will light when SD/USB device is playing or flashing when
paused .
BUTTON FUNCTIONS
Remote Control Eye -
do not block.
FM/USB/SD ON/OFF
- turn MP3 player ON/OFF.
Play/Pause/Record
- use for SD/USB function.
10+/Folder -
move ahead 10 selections (SD/USB).
/ FM UP
- advance forward to next song / advance up to
next FM frequency .
/ FM Down -
move back to last song / advance down
to next FM frequency .
10-/Folder -
move back 10 selections (SD/USB).
Mode / FM Recall -
use to select Repeat last song/folder/
or all songs on SD/USB device. Press to move to next FM
station in memory.
A-B / FM Scan Memory -
use to set length of repeat on
SD/USB device. Press to auto scan local FM stations and place in memory.
Display Window
WIRELESS MICROPHONES
MICROPHONE INPUT JACK
LAPEL / HEADSET
POWER SWITCH
OFF—STANDBY—ON
BATTERIES
Handheld Wireless Microphone
- Screw off the lower bottom section of microphone, notice the “+” and
“-” signs on base. Insert a 9V battery. Screw battery cover back on.
LED
will turn
RED
when battery is low.
Wireless Bodypack
- Slide open the case and insert a 9V battery.
9 V Rechargeable batteries can be recharged inside of the
SW245
(see Battery Compartments).
Battery life is about 8 hours.
CAUTION! Batteries supplied are not rechargeable.
MICROPHONE OPERATION
Turn on
SW245.
Set Wireless Microphone Volume Control
(1)
at half way.
Handheld Wireless Microphone -
Slide switch to the "
ON”
position. Green LED will light on
front of speaker to show that signal is being transmitted and received. Talk into microphone and
adjust volume. Middle position is MUTE. Slide switch to
“OFF”
to save battery power.
Wireless Bodypack
- Connect either the Lapel or Headset Microphone into the input jack on the
Wireless Bodypack. Set Gain Control at half way. Slide the Power Switch to “
ON”.
Red LED will
light on bodypack and Green LED will light on front of speaker to show that signal is being trans-
mitted and received. Speak into microphone and adjust the Gain control to desired loudness.
NOTE: The center position of the Power Switch is to be used when you want to temporarily
quiet microphone.
NOTE:
The
orange sticker with a number
that is attached to the;
SW245
, Wireless Handheld
Microphone and the Wireless Transmitter Bodypack refers to the wireless frequency. All three
stickers must have the same number for the wireless to operate correctly.
20 21
24
27
22
25
28
30
31
19
32
23
26
29
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
33
