User Manual of W20-GSM Indoor single band selective repeaters
Confidential Page
9
Installation Steps:
A) Use percussion drill to make four
Φ
6 holes on the wall according to
above hole diagram.
B) Fill the holes with expanding plug
C) Put the tapping screw through the holes and fit tightly with the
expanding plug, and fasten the repeater onto the wall.
D) Make sure that the installation is firm and correct
4.3
Connection
Connection of RF cable
Input Port : donor antenna cable is connected with BS Port;
Output Port : service antenna cable is connected with Output Port;
Grounding
Please connect one end of a copper wire with the intersection size of
16mm2 with the grounding screw, and the other end with the grounding system
of the building. It is requested that the grounding impedance shall be less than
10Ohm.
Power supply connection
Installation of air switch is recommended for the convenience of power
supply switch off.
Please use three-pin plug to assure good grounding
Please use the grounding screw, nut, washer to connect the grounding wire and
repeater shell
Lightening Arrestor can be installed if necessary
