HI Knob
To adjust the high eq.
BOOST Knob
To adjust the mid boost. The more you use BOOST the more it will bypass the LO-MID-HI settings. Turn this knob if you
want to get more British sound or feel that your guitar is not cutting through enough. This knob will have great effect for your
sound.
GAS Knob
To adjust the master volume. This controls signal to the power tubes. If you want dynamics and headroom turn this to the
max and adjust volume with DRIVE.
BRILL Knob
To adjust the high eq before power tubes. With this you can control the sound to be sharp or warm.
BASE Knob
To adjust the power amp feedback. This also affects the low sound volume. In minimum position you get more feedback
and presence and in maximum position there is no feedback. If your guitar sounds too muddy turn this counterclockwise.
You can then use GAS knob to turn level back up and also add some clarity.
RUN Switch
To switch on the high voltage. You are ready to rock!
HEAT Switch
To turn the machine on. In correct operation keep the RUN switch turned off and warm up power tubes for a minute.
INPUT Jack (left side)
To connect your guitar.
Footswitch Jack (right side)
Footswitch connector.
BACK panel
CH
F.SW
OHM
4
8
16
F T2A
230
LINE
OUT
SEND
OUT
9V
0.5at
15w
6v6
30w
PAR
SER
RET
EFF.LOOP
230/115 VAC Switch
To adjust the voltage. Check your operating country before connecting mains.
MAINS Input
To connect the mains cable. This connector contains the main fuse: 2.0A and remember to use slow blow fuse.
9V Connector
RCA with . 9V buzz free output for effect pedals.
OHM Selector
To adjust the impedance. Switch to correct setting according to combined speaker impedance.
OUT Jacks
To connect your speakers. Remember to connect your speaker before powering the unit. These are parallel
connections so e.g. connecting two 8-ohm cabinets turn this to 4-ohm position.
LINE OUT Jack
Output from the speaker line. This can be used for PA and recording purposes. Output impedance 3.3 Kohm.
Fuse
500mA slow blow anode fuse. This might be blown cause of possible tube breakage.
