AMPHIBICO Dive Buddy EVO HD, Instruction Manual, Page: 9 / 22

Rear LCD Monitor (continued)
Settings for the rear LCD monitor are located on
the inside of the rear bulkhead and are described
as follows: COLOR To adjust color saturation
BRIGHT. To adjust the brightness CONT. To
adjust the contrast
WARNING:
IT IS IMPORTANT TO REMOVE BATTERIES
FROM BATTERY HOLDER AFTER EVERY USE.
FAILURE TO DO SO MAY DRAIN
THE BATTERIES OVER TIME AND CAUSE
SEVERE DAMAGE TO THE UNIT.
Closing the housing
1. While the housing is open, inspect the two O-rings and the sealing surface for dirt and debris. If
necessary, clean them with a lint free tissue. Make sure that the two O-rings and the sealing surface
are clean. Then apply a small amount of lubricant to the O-rings.
NOTE: If you have to change your O-rings, make
sure you are using the o-rings provided with the
package. Using different o-rings than those in the
O-ring kit may cause the housing to leak and result
in damage.
Silicone grease provided with
the o-ring kit.
2. Make sure the camera and the cables don't block the sealing surface. If cables get pinched, the
system might be intermittent or not functioning at all. Once the camera is completely in and the
saddle is locked, engage the latch by turning it clockwise.
3. Make sure the o-rings are well placed before locking the latch. Turn the latch until a positive click
is felt.