RESMLAC 8MG CAPS POE - UM
rev. 1
Page 5/16
www.amphenol-socapex.com
Tel: +33(0)4.50.89.28.00
OFF – No link and No Data
POE
Indications
POE
Port number
Orange On – port power is
activated over 2 pairs
Green On – port power is
activated over 4 pairs
Green Blink at 1Hz – Overload
or short circuit is detected on
port output lines
Green Blink at 0.5Hz – A valid
POE load is connected to port
output lines, but PSE has no
sufficient power for supplying
the required load power
Section 3
Installation
Selecting a
Site
As with any electronic device, you should place the switch where it will not be subject to
extreme temperatures, humidity, or electromagnetic interference that exceeds the
RESMLAC-8MG-CAPS-POE profile. Specifically, the site you select should meet the
following requirements:
•
The ambient temperature should be between -45 to +85 degrees Celsius.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461E.
CAPS for
unused
connectors
The switches are pre-equipped with caps on all ports, including power and Ethernet.
Make sure all connectors are protected with cap or sealed plug to ensure sealing
and prevent from deterioration of the contacts.
Mounting
The RESMLAC-8MG-CAPS-POE Ethernet Switch can be fastened to any flat surface by
mounting the box directly. Refer to the mechanical drawings below. Make sure to allow
enough room to route your Ethernet and power cables.
The RESMLAC-8MG-CAPS-POE weighs 2.2 Kg and is mounted via its four 5.2 mm holes
for screws.
The overall external dimensions of the RESMLAC-8MG-CAPS-POE are 269(L) x 133(W) x
75(H) millimeters.