H4
系列连接器安装手册
H4 SERIES
I
NSTRUCTION MANUAL
文件编号
(File Name)
:WI-S037-ENG
SOP-001QF-07 REV.A
Page 3 of 19
1.
警告
Caution
1)
连接器在安装或拆卸过程中必须断开电源。
The connector must be isolated and disconnected from the power supply during the assembling or
disassembling process.
2)
不可带电插拔。
Do not disconnect under load.
3)
推荐使用光伏电缆线。
The use of PV cable is recommended.
4)
推荐使用镀锡线芯线材。
The use of tin plated cable is recommended.
5)
安费诺连接器配合状态符合
IP68
（水下
1
米一小时）密封性能。
The connectors are IP68 mated, and can be positioned for short time under 1MT of water.
6)
该产品应由有相应资质或经过专家培训的、具备相关安全应用规范的专业人员安装。
The connector is considered to be in compliance with UL 6703 only when assembled in the manner specified
by assembly instructions.
7)
该连接器只适用于
B
类和
C
类的铜导线
(
参考
NFPA NEC 70
第
9
章
,
表格
10)
。如果与其他等级的铜导线使用，
连接器应做标记。参考电缆导体标准：
UL 486A-486B
。
This connector is suitable for use only with Class B and C stranded copper conductors (See NFPA NEC 70
chapter 9, Table 10)”. If the connector is found to be suitable for use with other stranding classes, the
connector shall be marked with those class conductors. See the Standard for Wire Connectors, UL 486A-486B.
8)
H4
系列连机器沿其轴向可承受最大
44LB
拉力，如图
1.1
所示。但不可使用如图
1.2
所示非连接器轴向力
来拉连接器。
The H4
，
H4-H and Enlarge H4 can withstand the pull force 44Lb MAX. along the direction of picture 11.1
shows at the coupling interface.
The force like picture 1.2 shows is forbidden.
图
1.1
图
1.2
picture 1.1 picture 1.2
