Parts Identification
2
PAGE 2
iPX5151 | ETHERNET PAGING CLIENT
3
6
7
1
Front View
Rear View
9 10
5
4
8
POWER - This blue LED shall lit when iPX5151 is powered On.
SERVER - This green LED shall lit when iPX5151 successfully establish a connection with Paging Server (iPX5101).
STATUS - Blink whenever there is a network activity ongoing.
STREAMING - Blink whenever iPX5151 start streaming audio to a receiving paging client (iPX5155).
1. INDICATOR LEDS
24V DC power supply input.
2. POWER PORT
Ethernet port for connecting to network switch.
3. ETHERNET PORT
Button to allow iPX5151 enters Bootloader mode or reset settings to factory default settings.
Bootloader mode: To enter this mode, hold the reset button until POWER, SERVER and STATUS LEDs lit. Enter this
mode to do firmware updating if normal mode updating does not work. All iPX5151 settings remain intact in this mode.
Reset to factory default settings: Hold the reset button until POWER, SERVER, STATUS and STREAMING LEDs lit
will reset all iPX5151 settings to factory default settings.
4. RESET BUTTON
This ports provide a dry contact which can be used as E/M overriding signal or activate ALL CALL at speaker zone selector.
5. RELAY CONTACT
We can activate iPX5151 paging using voltage free dry contact. Link PM series paging mic / MR1301 message recorder / TI6100
Telephone Interface dry contact to this port will allow these audio sources activate iPX5151 and have their analog audio accepted by
iPX5151.
6. REMOTE TRIGGER PORT
For data transmission between PD paging mic and iPX5151.
7. RS485 PORT
This LED shall blink according to the rhythm of the input paging mic audio.
8. SIGNAL INDICATOR
Connect paging mic or other audio source analog audio to this port. The signal shall be in balanced line level.
9. AUDIO INPUT PORT
Audio that sending to Audio Input Port shall also broadcast via this output port. The signal is in balanced line level.
10. AUDIO OUTPUT PORT
