AMP HSP1 Quick Start Manual Download Page 1

Page: 1 / 2

For Technical Support, Contact AMP

at (775) 345-9933 (9 am - 5 pm PST)

or [email protected]

Connect amplifier RF output SMA connector to antenna

Verify the connected transmitter’s output power is less

than the maximum input power rating (noted on HSP1

chassis) of the HSP1 power amplifier, then connect the RF

output from transmitter to RF input SMA connector.
Wire power, enable, and high/low power control (if

applicable) *see reverse side

STEP

Note

When setting up your system, the transmit and receive

antennas should be greater than 25 feet apart to

prevent serious damage to or destruction of the

receiver’s front end

HSP1 Power Amplifier Quick Start Guide

Summary of Contents for HSP1

Page 1: ...ing noted on HSP1 chassis of the HSP1 power amplifier then connect the RF output from transmitter to RF input SMA connector Wire power enable and high low power control if applicable see reverse side...

Page 2: ...the yellow wire shown above To set the amplifier to the higher output power level leave the yellow wire open unconnected To set the amplifier to the lower output power level connect the yellow wire t...

Brands by name