www.amp-research.com
IM75163 rev 01.02.20
8/10
A M P R E S E A R C H P O W E R S T E P
T M
– S P R I N T E R
6
9
17
18
Ground terminal located
on floor.
19
21
22
9
20
Remove Drivers seat box cover. Be careful not to
damage wire that runs across cover.
Connect positive terminal on power lead using a
10mm socket or wrench. Connect ground to body
ground in bottom of seat box. Remove Fuse.
Insert
Tighten
Strip 3/8”
Insert and
Tighten
Splice Power Step trigger wires into the Door
Ajar wires with provided Posi-Tap
TM
splicers. The
Power Step trigger wires color coordinate with the
factory Door Ajar wires. Follow the steps below to
correctly splice wires.
Route remaining wires up and over exhaust heat
shield and back along passenger side to motor.
Remove side access panel. Locate grommet under
passenger side seat. Pull trigger wires up through
grommet in floor.
Rear Door:
Located in the loom under the seat look
for the pink with a white stripe wire for the rear door.
Attach pink trigger wire on harness to pink with a
white stripe wire.
