[email protected] • 813.978.3900
–5–
Install Lens and Faceplate
3
Place the lens, gasket, and faceplate back
onto the housing. Secure them with the
screws previously removed. Hand tighten
until snug, then use a srewdriver to secure
them in a star pattern.
Screw
Housing
Lens
Faceplate
Gasket
Install Stake
4
Determine the desired location for
mounting the fixture. Hammer the stake
into the ground until flange of stake is flush
to grade. To avoid damage to the stake,
place a board on top of the stake while
hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut
in the ground using a flat shovel before
hammering the stake.
Board
Stake
Soil
Ground
