Install Stake
1
Board
Ground
Soil
Stake
- 4 -
- 5 -
Install Luminaire to Stake
2
Ground
Supply Wires
Wireway Slot
Soil
Stake
Luminaire
Determine the desired location for mounting
the luminaire. Hammer the stake into the
ground until flange of stake is flush to grade.
To avoid damage to the stake, place a board
on top of the stake while hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut in the
ground using a flat shovel.
Clear away an area in the ground
at the wireway slot on top of the
stake. Lay the luminaire pigtail
into the wireway slot and attach
the luminaire onto the stake.
Tighten until snug.
Wire Connections
3
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Main Low Voltage
Supply Cable
Wire Connectors
Remove Glare Guard
4
Loosen the set screw and remove
the glare guard from the fixture
body.
REMOVE
Fixture Body
Set Screw
Glare Guard
Remove Lens
5
Rotate the lens to remove it
from the fixture body.
REMOVE
ROTATE
Fixture Body
Lens
AMP
®
EscherPro MR11 Spotlight
AAL-1023
INSTALLATION & MAINTENANCE GUIDE
w w w. a m p l i g h t i n g . c o m
[email protected] • 813.978.3900
