TEC 2500 Water Bath-Slide Drier
HESTION 201301040001EN
---5---
---5---
TEC2500 Water Bath-Slide drier
Ver:AMOSTEC2500OP20161115
5. Repeat the above process to set the temperature in the warmer.
6. After setting the temperature in the bath tank, oven and warmer, press Start till the lamp start
lights. At the moment, heating begins. When the set temperature is reached, press Start again to
heating stops and the set temperature is kept constant.
Note: Normally, heating should begin half an hour before operation.
◆
How to check the temperature to see if it reaches the set value
After the equipment is heated for a period of time, press the key Test/set to check the temperature in
the bath tank, oven or warmer as follows:
To check whether the temperature in the bath tank, for example, reaches the set value, press
the key
till the lamp Bath lights, and then press the key Test/set till the indicator Test
lights. The value shown by
℃
is the current temperature in the bath tank. The current
temperature in the oven and warmer is also checked in the same way.
A
fter using of the equipm
ent, press the key start till the indicator start goes out and then turn off
the power switch at the rear of the equipment.
6
．
Cleaning
＆
Maintenance
●
The input power supply must have good earth connection
●
The bottom of water bath box must keep dry for fear of creep aging or bobbling heating up
piece. Keep the equipment clean for fear of influencing the control of temperature.
●
Take care that the outside heating up piece hurt you.
●
Install fuse as figure(1) shown then put it into the installation part as figure(2)shown.At last
put the whole installation into the receptacula as figure(3)shown.
●
Before replacing the fuse must turn off the power switch and disconnect the power.
Specification of fuse: 5A
（
220V
）
,8A(110V).
3
2
1
