background image

III

Federal Communications Commission (FCC) Statement

15.21

You are cautioned that changes or modifications not expressly approved by the 

part responsible for compliance could void the user’s authority to operate the 

equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules.Operation is subject to the 

following two conditions:

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that 

may cause undesired operation of the device.

FCC RF Radiation Exposure Statement:

For body worn operation, this phone has been tested and meets FCC RF 

exposure guidelines when used with an accessory that contains no metal and 

that positions the handset a minimum of 1.5 cm from the body. Use of other 

accessories may not ensure compliance with FCC RF exposure guidelines.

Summary of Contents for IOT-800









Reviews: