Setting the internal jumpers - continued
Inside the APU-RS8E
To set the jumpers the lid of the
APU-RS8E must be removed by
carefully unscrewing the four machine
screws on the sides of the chassis.
The jumpers for each channel are
positioned as indicated in the diagram
below.
Diagram 1: Internal circuit board layout of APU-RS8E
Important:
Ensure that the jumpers are fully pushed down onto the
pins.
Only remove and replace the lid fixing screws by hand.
Always use the correct tool and do not over tighten.
Ensure the lid is securely fitted to the product before it
is installed.
Mark each channel’s fuse setting on the product serial
number label for future reference.
