45
1. Operational safety.
All safety instructions included in chapter IV must be observed. Textile grease filters and carbon filters
should be replaced and aluminium filter should be cleaned according to manufacturer’s instructions, or
more frequently in periods of intensive use (more than 4 hours a day). If a gas cooker is used it is for
-
bidden to leave uncovered flame. When removing pots from gas burners set the flame to its minimum
level. Always make sure that flame does not extend outside the pot. Such a situation causes undesired
energy losses and dangerous heat build-ups. The hood should not be used for other purposes than
those for which it was designed.
VI OPERATION AND MAINTENANCE
2. Operation:
2.1 Control panel
Operation of the hood can be controlled by means of switches „W” and „O” (Fig. 4):
- switch „O” controls lighting. Shifting the switch to the left turns the lighting on, to the right - turns the
lighting off.
- switch „W” is used to control the hood motor. Successive shifts to the left turn on three fan operation
speeds. These control options enable the user to set the optimum fan speed for his requirements at
minimum noise.
EN
3. Maintenance.
Regular maintenance and cleaning of the device will guarantee its good and fault-less operation, and
extend its life. Attention should be paid to replacing grease and carbon filters according to instructions.
3.1 Grease filter
1. Cleaning.
Grease filters should be cleaned every two months during normal operation of the hood, in a dishwasher or manu
-
ally, using mild detergent or liquid soap.
2. Replacement (Fig. 7).
To dismantle the filter proceed as follows:
a) remove the bottom cover by releasing the lock catch,
b) remove the metal grease filter
Summary of Contents for OKC 5662 I
Page 4: ...4 1 3 5 2 9 ...
Page 5: ...5 6 7 ...
