40
OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the cooker
disconnect the mains plug
call the service centre
some minor faults can be fixed by referring to the instructions given in the table below.
Before calling the customer support centre or the service centre check the following points
that are presented in the table.
PROBLEM
POSSIBLE CAUSE
REMEDY
1.The appliance does not
work
- no power
-check the fuse, replace if
blown
2.Sensor fields do not re-
spond when touched
- appliance is not turned on
- turn on the appliance
- sensor field touched
too briefly (less than one
second)
- touch the sensor field
longer
- multiple sensors touched
at the same time
- always touch only one
sensor field (except when a
cooking zone is switched off)
3.the programmer display is
flashing “0.00”.
-
the appliance was disconnec-
ted from the mains or there was
a temporary power cut.
-
set the current time
(see ‘
Use of the programmer’
).
4. the oven lighting does not
work
-
the bulb is loose or damaged
-
tighten up or replace the blown
bulb (see Chapter
Cleaning and
Maintenance)
5.The induction hob does not
respond and beeps briefly
- child lock feature is active
- deactivate child lock
feature
6.The induction hob does
not respond and emits and
extended beep
- improper use (wrong
sensor fields touched or
sensors touched too briefly)
- reconnect the hob
- sensor fields covered or
dirty
- uncover or clean the sen-
sor fields
7.The induction hob switches
itself off
- no sensor field is touched
for 10 seconds of activating
the appliance
- switch on the appliance
and set heat setting without
delay
- sensor fields covered or
dirty
- uncover or clean the sen-
sor fields
8.A single cooking zone swit-
ches off and residual heat
indicator „H” is shown.
- limited cook time
- switch on the cooking zone
again
- sensor fields covered or
dirty
- uncover or clean the sen-
sor fields
- electronic components
overheated