DISPLAY AND CONTROL PANEL
23
7
Anti-Crease button
At the end of the drying cycle,the anti-crease phase time is 30 minutes (default )
or 120 minutes (selected).
This function prevents the laundry from creases. The laundry can be removed during
the anti-crease phase. Except [Time cool], [Time warm] and [Refresh], all the other
programmes have this function.
*Steam
Steam removes an odour, as the outdoor air.
Decreases or removes creases. Makes the pieces of clothing more flexible.
The pieces of clothing after steam programme are easy to iron.
When “Steam” function is selected with “Refresh”, the wrinkles on the dry clothes
(within loading limit) could be removed. When “Steam” function is selected with
“Shirts/Delicate/Extra”, the wrinkles on the drying clothes could be decreased. Each
time when “Steam” function is selected, fill about 300ml purified water to the inlet at
the water-tank bottom.
At the start, because of wide types of fabrics, apply small steam loads. You easily get the ex
-
perience, which helps you to use the sufficient steam loads. At the end of cycle, if you will not
iron, put the pieces of clothing on the clothes hanger.
Use only distilled or demineralized water. Always when the tank is empty the indicator
is on
and you cannot start the steam programme.
For the first time you can use the water attached in the bottle. The condensed water is also
applicable for steam system. The condensate water must be filtered e.g. with a coffee filter
to remove small pieces of fluff. If you dry with standard and steam programmes, the tank for
steam system fills automatically.
To fill the tank:
1. Turn on the appliance.
2. Set one of the steam programmes.
3. Pull the tank. Keep it in horizontal position.
4. Fill the water until the signal
disappears.
The acoustic signal sounds when the tank for steam
system is full.
5. Put back the tank.
8
Lamp button
The lamp inside the drum will be on for lighting about 3 minutes when the button is
pressed or 1 minute when the door is open.
*Available on selected models
