Rev: 09.2017
TAF Pre-Engineered Skid IOM
4
SAFETY INSTRUCTIONS
General
1. Prior to installation or any treatment given to the filter, read carefully the installation and
operation instructions.
2. While maintaining the filter all standard safety instructions should be observed in order to avoid
danger to the workers, the public or to property in the vicinity.
3. Please note, the filters enter into a flushing mode automatically, without prior warning.
4. No changes or modification to the equipment are permitted without a written notification given
by the manufacturer or by its representative, on the manufacturer behalf.
Installation
1. Install the filter according to the installation instructions detailed in this manual.
2. Make sure to leave enough clearance so as to enable easy access for future treatments and safe
maintenance operations.
3. Electric wiring should be performed by an authorized electrician only; using standardized and
approved components.
4. Install main power disconnect cut-off switch close to the control panel.
5. If the control panel is installed in a location where there is no eye contact with the filter, a
power disconnect cut-off switch should be installed near each filter unit.
6. Install the filter so as to avoid water splashing directly on the electrical components or on the
control panel.
7. Additional safety devices should be installed on hot water applications to avoid skin burn
danger.
Operation, Control and Maintenance
1. Disconnect the filter from power supply before maintenance or treatment.
2. Loosening or unscrewing bolts should be done only after the pressure in the filter had been
released.
3. Avoid splashing and water leaking so as to minimize slipping, electrocution or damage to the
equipment caused by moisture.
4. Always open and close valves slowly and gradually.
5. Remove grease and fat material residues in order to avoid slipping.
6. After treatment has been completed, re-assemble the protection covers of the drive mechanism.
7. Manual cleaning of filter element using high water pressure or steam should be performed in
accordance with the cleaning system instructions and without endangering the operator or his
vicinity.
8. Manual cleaning of filter element using acid or other chemical agents should be performed in
accordance with the relevant material safety instructions and without endangering the operator or
his vicinity.
Use of Lifting Equipment
1. While using lifting equipment, make sure that the filter or the lifted part is chained securely and
in a safe manner.
2. Do not leave lifted equipment hanging if not necessary. Avoid working below lifted equipment.
3. Wear a safety helmet while using lifting equipment.
