COPYRIGHT © 2010 AMI ENTERTAINMENT NETWORK, INC.
MEGATOUCH ION AURORA OWNER’S MANUAL PM0636-14
Monitor Adjustment Procedure
The vertical/horizontal controls and bright-
ness/contrast controls are located on the
OSD board, inside the CPU section near the
hinge of the door. Pressing the button la-
beled
Menu
on the OSD board will show
the on-screen display on the monitor. Use
the Left and Right buttons to move through
the menu. Touch Menu again to select the
option you want to change. Use the Left
and Right buttons to change the option. Then
select Menu again to deselect the option.
Auto will automatically adjust the size and
brightness. Touch the Exit button to exit.
Adjust the monitor controls until the screens
look as suggested in the following steps.
1.
Set the game to the Checkerz game
screen.
2.
Adjust the vertical and horizontal size
and vertical and horizontal position to
make sure that the game screen fills
the monitor screen and that the game
screen is centered.
3.
Adjust the brightness and contrast con-
trols until the top sets of checkers are
a rich red and the bottom set are a dark
gray. The feet on the
“Checkerz”
character should be white. (Adjusting
the brightness and contrast can also
correct for a lack of sharpness.)
NOTE: If you are experiencing an issue
where your screen seems to be slightly
shifted, repeat the screen calibration
process, pressing “Auto” on the OSD
board when each new calibration
screen appears BEFORE calibrating the
screen for that resolution.
General Circuit Board Handling
Information
Before handling any boards, observe the
following procedures:
•
Prevent Electro-Static Discharge by:
1. Storing the boards in the anti-
static bags in which they are
shipped.
2. Removing any static charge
from your body before handling
the boards.
3. Using a ground strap when
handling the boards.
•
When plugging in connectors to the
board, make sure the connector is
inserted straight onto the header and
that the connector covers all header
pins.
•
Do not connect any peripheral device
to the board, if the power is still
connected to the peripheral or if power
is already applied to the board.
CAUTION
: Be extremely careful when re-
placing the lithium battery on the mother-
board. There is a danger of explosion if the
3
it. Then move the joystick as far left as
it will go, release the joystick, and press
one of the buttons on the joystick.
NOTE: The joystick may not appear to
be functioning correctly during cali-
bration, but it is important that you
continue the calibration steps. After
calibration has been completed, it will
function properly.
•
Move the joystick as far right as it will
go, release the joystick, and then press
one of the joystick buttons.
•
Move the joystick as far up as it will go,
release the joystick, and then press one
of the joystick buttons.
•
Move the joystick as far down as it will
go, then release the joystick and press
one of the joystick buttons.
•
Then, without touching the joystick,
press one of the buttons on the joy-
stick to complete calibration.
•
Touch the
EXIT
button.
