AMI Analyzer Manual
••••
20
Hygienic practices:
Wash hands after handling
Protective clothing:
Rubber gloves, chemical splash goggles.
Clean up procedures:
Wipe down the area several times with a wet paper towel, using
a fresh towel each time.
Protective measures during cell replacement:
Before opening the bag containing the sensor, check the sensor
for leakage. If any is found, do not open the bag. If there is
liquid around the sensor installed in the instrument, put on
gloves and eye protection before removing it.
Disposal:
Must be in accordance with all applicable federal, state and local
regulations.
EPA waste number:
D008
California waste number:
181
DOT information:
RQ Hazardous Waste Solid N.O.S. (lead), 9, UN3077, PG III
Advanced Micro Instruments. Inc. shall not be held liable for any damage arising out of using or abusing this
product.
Sensor type P2
Product Identification
Product name:
Oxygen sensor, class P2
Manufacturer:
Advanced Micro Instruments
Address:
Phone:
(714) 848-5533
Date of last revision:
11/08/2004
Emergency phone number:
(714) 848-5533
Physical and chemical data
Composition:
The sensor body is made of metal and glass-epoxy GR4 circuit board material, with a Mylar covering.
It contains the following substances (other than various plastics):
Common name
Formula
Concentration
CAS number
Potassium hydroxide solution
15%
KOH
15%; 1-5ml
1310-58-3
Lead
Pb
pure, 3-20 g
7439-92-1
