AMI VR2272B
Doc No: AMI OM2272BA
CLASSIFICATION: Commercial In Confidence
Page 17 of 28
17
4.4.2 HVR Thread Fail
If the L3 Capsule has been supplied with the (S)VDR system then it is possible that
you will see the ‘HVR Thread Fail’ error message.
This is due to the L3 Capsule being configured incorrectly.
Please follow the below procedure to correct this error:
Ensure the VR2272-B LAN IP Address is set to 192.168.0.5.
This is done as follows:
Start – Control Panel – Network Connections
Right Click on Local Area Connection and Select ‘Properties’
Highlight ‘Internet Protocol (TCP/IP)’ and select ‘Properties’
Select ‘Use the Following IP Address’
IP address – 192.168.0.5
Subnet Mask – 255.255.255.0
Default gateway – 192.168.0.2
Open Internet Explorer
In the Address Bar type 192.168.0.2
Click on Flash Setup
When asked enter password “l3hvr”
Select Position 0
Change the number of ‘Granules’ to the same number as seen in ‘Partition Granules
in Crash Module’
In Stream Name of ‘Partition 0’ enter the word ‘RADAR’ - uppercase
Enter ‘0’ in the ‘Granules’ field of the other partitions.
Submit Changes
This creates a single large partition to which all data will be written.
