24
VI. OPERATION INSTRUCTIONS
To lift vehicle
1.
Keep clean of site near the lift;
2.
Position lift arms to the lowest position;
3.
To shortest lift arms;
4.
Open lift arms;
5.
Position vehicle beside of the lifting arm, car should at the other side of the column;
6.
Move arms to the vehicle’s lifting point;
Note:
The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7.
Turn on the power of the power unit and press
up
button until the rubber pads fully
contact the car, making sure it is safe;
8.
Slowly lift the lift. Make sure that the car is in a balanced state, then lift the car to the
required height and release the
UP
button
9.
Press the release handle of the power unit and lower the lift to the safety lock position.
Only after confirming that the safety device is in a normal working state then the car
can be maintained.
To lower vehicle
1. Be sure the clearance of around and under the
lift, only leaving operator in lift area;
2. Press the start button of the power unit to raise the vehicle slightly, and then open the
safety device, then lower the vehicle by pressing the release handle of the power unit;
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
Summary of Contents for SPL-6
