8
D. Install parts of extension columns
(See Fig. 15).
E. Position power-side column
Lay down two columns on the installation site
in parallel
, position the power-side
column according to the actual installation site. Usually, it is suggested to install
power-side column on the front-right side
of the direction
which vehicles are driven
to the lift. This lift is designed with 2-Section columns.
Adjust the
height according to
the ceiling height and
connect
the inner and extension columns.
OH-9, OH-10: Not suitable for installation when the height of the workshop is less
than 143-3/4"; only low setting installation for height between 143-3/4" - 151-1/2 ";
the height of the workshop is greater than 151-1/2", installation can be in both high
and low setting;
OH-9H, OH-10H: Not suitable for installation when the workshop height is less than
167-3/8"; only low setting installation for height between 167-3/8" ~ 175-1/4"; the
height of the workshop is greater than 175-1/4”, installation can be in both high and
low setting;
Fig. 15
26
37
25
24
23
41
42
Summary of Contents for OH-10
