AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 9 of 12
AMG5913-2A9 Instruction Sheet
D22183-00.doc
be accessed by removing the 2 fixing screws in the rear panel and sliding the PCB out of the
enclosure.
For clarity, in the 3 examples shown below all 4 data ports D1-D4 are terminated the same, but each
data channel may be configured & terminated independently as required. The 3 examples shown are
RS-232 (no termination), RS-422 (120
Ω) or RS-485 (120Ω).
Alarm Channel Configuration
The
AMG5913-2A9
provides 8 bi-directional contact closure inputs / alarm outputs.
Each ALARM IN input is via an internal 10k
Ω series resistor with a 47kΩ pull-up resistor to the internal
+3V3 supply.
Each ALARM OUT output can receive an on/off signal from an
AMG5914-2A9
and is typically used to
convey contact closure status. Each alarm output is an NPN open collector circuit with a maximum
rated continuous load of 500mA / 24Vdc.
Alarm Channel Circuit
The output of each alarm channel is an NPN open collector transistor circuit, with an absolute
maximum rating of 1A / 60V. There is a common GND for all alarm channels.
