AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility is
assumed by AMG for its use.
Page 6 of 7
AMG2684 Instruction
Sheet D15700-00
SW1 Switch Settings
All SW1 switch settings are set at the factory as follows:
Channels 1-4 Card
Switch
Position
Description
Setting
1
Video channel configuration
OFF
2
Video channel configuration
OFF
3
Video channel configuration
OFF
4
Primary / Secondary Board Setting
ON
5
Dual Redundant / Not dual redundant
OFF
6
Not Used
OFF
7
Not Used
OFF
8
On board data / Separate data card
ON
9
RS232 or RS422/485
OFF for
RS485/422
10
RS232 or RS422/485
OFF for
RS485/422
Channels 5-8 Card
Switch
Position
Description
Setting
1
Video channel configuration
OFF
2
Video channel configuration
OFF
3
Video channel configuration
ON
4
Primary / Secondary Board Setting
OFF
5
Dual Redundant / Not dual redundant
OFF
6
Not Used
OFF
7
Not Used
OFF
8
On board data / Separate data card
ON
9
RS232 or RS422/485
OFF for
RS485/422
10
RS232 or RS422/485
OFF for
RS485/422
Removal from the Case
Note: -
The 2600 PCB’s are static sensitive. Handle with proper care and use normal electrostatic
discharge (ESD) procedures. Use properly grounded protection (for example, wrist stamps) when
handling the PCB.
In order to remove the case (to access SW1 and SW2)
1.1. Loosen and remove the four screws on the top and bottom of the unit’s rear panel.
1.2. Slide the PCB assembly connected to the rear panel out of the case.
1.3. Ensure that the optical fibre is not trapped.
SW1 and SW2 can be found on the bottom right hand corner of each board and are labelled, close to
the rear panel. The switch position are labelled on the switch, switch position 1 is always the furthest