2.Determine on which side of the unit you want to install the
backrest. Make sure the unit will be facing the faucets with
the armrest on the inside of the bathtub (See Fig. 1)
3.To install the seat and backrest assembly, place the front
seat z-clamps under the front frame support tube. Lower
the seat back and snap the back seat white clips into place.
4.Adjust the unit to the desired height by pressing in the leg
push-button and sliding the leg upward or downward until
the button snaps into desired hole.
NOTE:
The transfer bench should be level. It is therefore possible
that the legs inside the bathtub may be adjusted to a height
different from the legs outside the bathtub.
5.Place the transfer bench as shown in Fig. 1. The inner legs
should be as close to the far wall of the tub as possible.
6.To remove the seat and backrest assembly from the unit,
lift the back portion of the seat while holding the frame
firmly in place. This will disengage the rear seat clips from
the frame tube.
