AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 4 of 8
AMG5814R-DF Instruction Sheet
D22166-00.doc
Connections
Video Output Connection
Connector .......................................... 75 ohm BNC Socket.
Output Impedance ............................. 75 ohm terminated.
Output Level ...................................... 1 Volt p-p nominal
Frequency Response ......................... 10Hz to 7MHz.
Optical Connection Multimode
Optical Fibres .................................... Multimode 50/125 or 62.5/125**
Connectors ........................................ SC/PC
Minimum Optical Launch Power ......... -15dBm
Transmit Wavelength ......................... 1310nm
Minimum Optical Sensitivity ............... -34dBm
Receive Wavelength .......................... 1310nm
Minimum Optical Dynamic Range ...... 19dB.
**Note : the maximum transmission distance is 2km. This is limited by the bandwidth of the Multimode
optical fibres.
Power Connection
Power supply ..................................... From plug in connection on the AMG2009 or AMG2015 subrack
Power consumption ........................... 2.5 Watts max.
Data and Alarm Channel Connections
No. of Data Channels ......................... 2
No. of Alarms ..................................... 8
Connectors ........................................ Removable 5-pin, 3.5mm, Spring Terminal
Connector Partnos. ............................ Phoenix 1952296
Data Interfaces .................................. RS-232 / 422 / 485. Selected by external slide switches D1-D2
RS-232
– Switch Position - Top
RS-422
– Switch Position - Middle
RS-485
– Switch Position - Bottom
Internal 120
Ω termination resistors may be applied to RS-422 or RS-485 inputs as required by internal
DIL switches inside the enclosure. *See appropriate section on how to remove the case for access to
the DIL switches.
Alarm inputs....................................... Input is via a series 10k resister with 47k
Ω pull-up to +3V3.
Alarm outputs .................................... Output is NPN open collector, maximum load 500mA @ 24Vdc.
Ethernet Connection
Ethernet Data Connector ................... RJ45
Interface ............................................ Auto-negotiation up to 100BASE-TX full duplex
Ethernet Data Rate ............................ Maximum 100Mb/s total Ethernet traffic on fibre
