AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility is
assumed by AMG for its use.
Page 5 of 5
AMG2743-SF Instruction
Sheet D15332-00
1.1. Loosen and remove the four screws on the top and bottom of the unit’s rear panel.
1.2. Slide the PCB assembly connected to the rear panel out of the case.
1.3. Ensure that the optical fibre is not trapped.
SW1 and SW2 can be found on the bottom right hand corner of each board and are labelled, close to
the rear panel. The switch position are labelled on the switch, switch position 1 is always the furthest
from the edge of the PCB.
When re-inserting the main PCB into the housing take care not to trap the optical fibre or the board
interconnection cables.
Fasten the rear panel with the screws.
Safety
The 2700 series of products uses a Class 1 laser system in accordance with EN 60825-2:2000.
However it is always advisable to follow good practice when working with optical fibre systems. This
includes:
Do not stare with unprotected eyes or with any unapproved collimating device at fibre ends or
connector faces, or point them at other people.
Use only approved filtered or attenuating viewing aids
For other safety issues and advice on good practice associated with the optical fibres systems see EN
60825-2:2000 or your local safety officer.
Maintenance
There are no user serviceable parts within the AMG2700 products.
In case of problem or failure contact your local support centre or AMG Systems Ltd, Technical Support
Department on tel. +44 (0) 1767 600777.
See unit data sheet for full specification.