Amewi PITBULL X EVOLUTION, Instruction Manual

Page: 13 / 25

INSTRUCTION MANUAL PITBULL X EVOLUTION
13
TROUBLESHOOTING
Error Cause Solution
Transmitter not working Transmitter batteries are empty. Replace batteries or charge if
rechargeable batteries.
Batteries are inserted incorrectly Insert the batteries correct
Range too low Transmitter batteries are empty. Replace batteries or charge if
rechargeable batteries.
Servos do not respond
properly Transmitter batteries are empty. Replace batteries or charge if
rechargeable batteries.
Servo gear broken Replace the gear or the servo
Engine will not start Defective spark plug Replace spark plug
Ignition coil slips Check the seat of the ignition coil.
Tank is empty Fill the tank
Fuel chamber of the carburetor is
empty Fill the chamber with pumps.
Carburettor not adjusted correctly Set the carburettor to factory
settings.
Combustion chamber full of fuel
(flooded) Unscrew the spark plug and pull
starter several times until the
combustion chamber is dry.
Air is sucked in via fuel line or
engine Replace the fuel lines and check the
location of the engine screws.
Possibly seals must be renewed.
Throttlek servo not set correctly Move throttle servo to neutral
position and readjust.
Fuel line, air filter or exhaust
blocked Clean blocked parts, replace if
necessary.
Engine gets no fuel Screw on the carburetor completely
screwed Reset all screws on carburetor to
factory settings.
Fuel line kinked Check the fuel lines
Engine starts, but goes out
immediately Tank is empty Fill the tank
Fuel line, air filter or exhaust
blocked Clean blocked parts, replace if
necessary.
Carburettor not adjusted correctly Set the carburettor to factory
settings.
Motor läuft nicht rund,
spricht schlecht an Dirty air filter Clean the air filter
Mixture too fat Turn the adjusting screw leaner.
Motor wird zu heiß Mixture too lean Turn the adjusting screw fatter.