![Amewi 22505 Manual Download Page 30](http://html.mh-extra.com/html/amewi/22505/22505_manual_2931519030.webp)
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL G101H
ENG
LISH
30
Never charge or use the battery if the cables are damaged or other damage is evident. The battery may only be charged using the
charging method intended for it. Otherwise there is a risk of damaging the battery.
If the battery is deeply discharged, charging is no longer possible. Please dispose of the battery at your local waste disposal facility
and obtain a new battery.
HOW TO USE A LITHIUM BATTERY SAFELY
•
If the battery is used improperly, it can cause an explosion.
•
We do not accept any liability for damage caused by improper use of the lithium battery.
•
It is strictly forbidden to use a charger other than the one supplied or a multifunction charger designed for lithium batteries.
Please ask your specialist dealer which charger is suitable for this battery.
•
It is strictly forbidden to dismantle the battery, short-circuit it, drop it or cause any other damage. Always keep sharp objects
away from the battery.
•
Never charge the battery unattended.
•
Keep the battery away from children. Children are not allowed to carry out the charging process.
•
Always charge the battery on a fire-proof surface and in a LiPo protective bag.
•
Dispose of damaged batteries at your local disposal company. Under no circumstances may batteries be disposed of with
household waste.
STARTING
REMOTE-CONTROL:
1.
Check all systems. Make sure the excavator battery is charged and connected. The excavator must be switched off.
2.
Make sure that all cables on the transmitter are in the home position.
3.
Press and hold the two ON / OFF switches simultaneously until the transmitter display starts to light up. This means that the
transmitter is now switched on.
If not all switches are in the basic position and if the
throttle lever is not in the middle position, the following
message is shown on the display: “Place all switches in their
up position and lower the throttle”.
Set the switches accordingly and switch on the Transmitter
again.
Press and hold the two power buttons on the
transmitter to switch it on.