AMETEK CTS
TWT Amplifiers
Quick Start and Safety Guide
V 1.0
5 / 10
WARNING: Do not touch the inner conductor of the RF-output connector.
High voltages can occur on the inner conductor of the RF output connector, or on cables or anten-
nas connected to it. These can cause RF burns if touched.
WARNING
:
The Amplifier is required to be connected to a suitable ground point.
The amplifier conforms with IEC Safety class 1, meaning that it is provided with a protective ground-
ing terminal. This is through the line supply cord to the centre pin of the power inlet connector. To
maintain this protection, the line supply cord must always be connected to the source of line supply
via a socket with a grounded contact. Do this before making connections to the RF-input or RF-
output connectors of the amplifier.
Without the protective ground connection, all parts of the amplifier constitute a potential shock hazard.
WARNING: Use the correct power cord.
Use only the line supply cord and connector specified for the amplifier. Use only a line supply cord
that is in good condition.
WARNING: Do not remove covers or panels.
To avoid personal injury, do not operate the amplifier without the panels or covers in place. Remov-
al of panels will expose the operator to high voltages that can remain in the amplifier after being
switched off for some time.
WARNING: Do not operate in explosive atmospheres.
The amplifier provides no explosive protection from static discharges or arcing components. Do not
operate the amplifier in an atmosphere of explosive gasses.
CAUTION: Avoid static discharges.
The RF input and output connections are static-sensitive and should
not be subjected to static dis-
charge.
CAUTION:
Do not obstruct the circuit breaker.
Ensure that there are no obstructions that impair the operation of the rear panel line-supply circuit
breaker(s).
CAUTION: Do not obstruct the airflow through the amplifier.
The cooling airflow is drawn in through the front and exhausted at the rear. If this airflow is ob-
structed, overheating of the amplifier may occur.
CAUTION: Do not operate the amplifier outside its specification.
This may cause the amplifier to malfunction or be damaged.
WARNING: Do not touch the exterior of the amplifier (rack mount version) when in use.
The top and side panels of the amplifier can get hot during use, especially on high power models.
CAUTION: Periodically replace the air-intake filters.
Operating the amplifier with the air filters dirty may cause the amplifier to overheat.
CAUTION:
Exercise caution when lifting.
The appropriate lifting practices should be observed during transportation, installation, or removal of the amplifi-
er from its mounting position.