Ametek Sorensen Asterion DC Series, Operation Manual

Page: 93 / 157

Asterion DC Series Calibration
M330460-01 Rev D 3-9
Figure 3-19. Ramp Screen Top Level Menu
The following menus are available in the Ramp top-level menu: Voltage Ramp and
Current ramp.
3.1.6.1 V
OLTAGE
R
AMP
The Voltage Ramp menu allows to configure and execute voltage ramp, refer to
Figure 3-20. The Voltage Ramp menu allows the selection of parameters such as
Volt , To Volt , Curr , Time and Trigger .
Figure 3-20. Voltage Ramp Screen
The Voltage Ramp menu has the following fields:
Entry Description
Volt Sets the start voltage for the ramp
To Volt Sets the end voltage for the ramp.
Curr Sets the Current limit for the ramp.
Time Sets the time in seconds to reach from start volt to end volt.
Trigger Sets the trigger mode for the ramp.
In SW (Software) trigger mode, the ramp is generated as soon as
the Trigger Ramp button is pressed.
In HW (Hardware) trigger mode, the ramp will be generated when
an active high pulse of 10ms is applied on the MOLEX connector
pin-8 (TRIGGER_IN) and pin-12 (DIN_RTN). Refer to Table 3-2
for PIN details.
Initialize Initializes the set Ramp parameters . Refer to Figure 3-21.
Press OK to return.