Asterion DC Multioutput Series
Programming Manual
M330517-01 Rev C
8-41
6
MON-RTN
MONITOR
RETURN
Return for Pin 7 and 8.
Pin 3
– PRG-RTN is shorted with Pin 6 – MON-RTN internal to the
power supply.
7
VMON
ANALOG
OUTPUT
Monitor signal for output voltage
Signal return: Pin 6
Range: 0 V to 10 V corresponds to 0-100% full-scale output.
Output
impedance: 100 Ω, typical
Minimum recommended Load: 100 kΩ, typical
Maximum Load: 20 kΩ
8
IMON
ANALOG
OUTPUT
Monitor signal for output current
Signal return: Pin 6
Range: 0 V to 10 V corresponds to 0-100% full-scale output.
Output impedance: 100 Ω, typical
Minimum recommended Load: 100 kΩ, typical
Maximum Load: 20 kΩ
Table 8-1: Remote Analog Programming Connector pin out details
The pinout function mentioned in Table 8-1 and Figure 9-2 is identical for each channel
connectors. To program desired channel corresponding analog channel connector to be
utilized.
CAUTION!
Return signal of all the three channels are shorted internal to the power supply.
Applying a voltage potential between the channel return signal of the individual
channels would damage the power supply.
CAUTION!
Analog programming interface signals are isolated from negative output terminal;
Isolation voltage is rated for ±600 V
RMS
maximum; operation of Isolated Analog
Interface signals should be at SELV safety voltage conditions to chassis ground.
Remote ANALOG Programming
Remote programming is used for applications that require the output parameters be
programmed (controlled) from a remote instrument. An external resistance or voltage can
be used as a programming source. External Source of programming (Resistance or Voltage)
is common for Output Voltage and Current when remote programming mode is selected as
External (EXT) or External + Internal (EXT + INT). When using remote programming, a
shielded, twisted-pair cable is recommended to prevent noise interference to programming
signals.
8.3.1
REMOTE PROGRAMMING BY RESISTANCE
Remote Analog reference source of the Output Voltage and Current can be selected as
resistance by sending the following SCPI Command:
SOUR<n>:ANALOG:PROG:SOUR CURR
Summary of Contents for Sorensen Asterion DC ASM
Page 1: ...M330517 01 Rev C Asterion DC Multioutput Series Programming Manual...
Page 6: ...Asterion DC Multioutput Series Programming Manual M330517 01 Rev C v SAFETY SYMBOLS...
Page 145: ...Asterion DC Multioutput Series Programming Manual 13 128 M330517 01 Rev C CAL n LOCK...
Page 162: ...M330461 01 Rev C 14 145...
