Ametek mocon Dansensor MAP Mix ProVectus, User Manual

Page: 54 / 80

52 User Guide EN Dansensor
®
MAP Mix Provectus
P/N 300862-K
11/2019
Mixer configuration
Selecting Mixer configuration from the General setup menu will display a screen where you
can configure the mixer.
Mixer mode Flow Flow mode
Buffer Buffer mode
MM8000 MAP Mix 8000 compatibility (2- and 3-gas mode)

In MM8000 mode all gas configurations have been

preset and therefore the GAS 1, 2, and 3 - Media

parameters are disabled.
Available gas configurations:
NOTE! Installation must match setting.


External start/stop Select whether or not mixer should be started/stopped via an
external signal.

When enabled the “Start” button in the main screen is disabled.
Analog control Disabled Analog control disabled.
Enabled Mix is controlled from the packaging machine via

analogue voltage signals (see below).

See also "I/O Cable" on page 21 for details.

For mixers in “MM8000” mode please refer to the

“MAP Mix 8000” User Guide for details.
Voltage Control 1 Select which gas is to be

controlled by the Voltage Control

1 input signal.
Voltage Control 2 Select which gas is to be

controlled by the Voltage Control

2 input signal.

Only applies to 3-gas mixers.
MM8000 mode Gas 1 Gas 2 Gas 3
MM8000 (CO
2
/N
2
) CO
2
N
2
MM8000 (N
2
/O
2
) N
2
O
2
MM8000 (CO
2
/O
2
) CO
2
O
2
MM8000 (3 gas
mode) N
2
CO
2
O
2
Mixer configuration