Dansensor
®
LeakPointer
H
2
O
EN
User Guide
27
Replacing the gas springs
NOTE! We recommend that two persons perform this operation, as the lid must be
held open while the gas springs are removed and mounted, respectively.
Required tools:
Flat tip screwdriver, small
1. Drain the tub
as described in
"Cleaning procedure" on page 22
.
2. Disconnect the drain hose
then remove the tub
.
3. Remove the original gas springs
. To do so, use a flat-tip screwdriver
to release the
locks
in both ends and press them downwards (upwards at the top) until you are able
to pull the springs off the pivots
(see detail).
4. Mount the new gas springs (before that the pivots
must have been removed from
them as described above).
5. Before mounting the springs, return the locks
to their original positions, then click the
gas springs onto the pivots.
$-*$,
Summary of Contents for mocon Dansensor LeakPointer H2O
