Ametek mocon Dansensor LeakPointer H2O, User Manual

Page: 14 / 36

12 User Guide EN Dansensor
®
LeakPointer H
2
O
P/N 390225-C
11/2021
Filling of water
General

Water temperature should be max. 50°C.

Add 1-2 ml non-alkali detergent to the water, to conserve it and make it softer.

If local water is very calcareous, we recommend to use de-mineralised water.
NOTE! Frequent cleaning is recommended to avoid bad hygiene and complicated
cleaning - see
"5. Cleaning and maintenance" on page 22 .


In general, it is always important to consider how much water should be in the tub

in
relation to the types of packages to be tested:
- If the purpose is to test relatively small packages, the tub should be filled so that the
surface is slightly above the underside of the hole-plate

when lid

is closed (approx.
25 liters - check scale

).
- If it is larger packages that can expand a lot during the test, the amount of water in the
tub must be adjusted so that the water level in the tub is somewhere between the
underside of the hole-plate

and the “Max” marking on the scale

when the package
is fully expanded during the test.

There are two ways to fill the tub with water. It can be filled either manually (see page 13 ) or
by using the vacuum function (see page 14 ).