Page 1
Installation Guide
NIR Thermal Imager
1 Introduction
This Installation Guide gives instructions on how to the install the Land NIR
Fixed Thermal Imaging System. The system is operated from
LIPS NIR
software.
These instructions are provided as a series of simple installation diagrams,
covering the installation of the NIR thermal camera and its mountings,
accessories and services.
The equipment must be used, maintained and serviced by properly trained
personnel, capable of following the procedures given in these instructions.
Safety may be impaired if the system is not used as indicated.
It is important to check the equipment with which you have been supplied
and then read these instructions thoroughly before proceeding with operation.
There are two basic installed configurations covered by this guide.
Imager
Optional
Purge
Blower
Optional
Water
Cooling
Control Computer
Optional
Remote
Computer
Optional
Input/Output
Signals
Optional
Protection Jacket /
Back Cap / Air Purge
Control Computer Installation
PSU Installation
Imager
Optional
Purge
Blower
Optional
Water
Cooling
PSU
Optional
Protection Jacket /
Back Cap / Air Purge
Capable of providing 12 to 30V dc
Max 1% ripple
Voltage outputs isolated from local ground.
