Ametek Land SPOT ACTUATOR, User Manual

Page: 23 / 38

4 - 5
Fixed Spot Thermometers
User Guide
SPOT Actuator
4.4 Control from the Remote
Use the Left and Right arrow buttons to move the actuator. A short press
moves it a single step, holding the button down will make it move further.
If the direction of movement does not correspond to your application (i.e.
pressing the left button makes the actuator appear to move to the right),
you can switch the direction in the webserver.
Press the circular button to switch on the LED (short press). To trigger
a Scan , press and hold the button for approximately 3 seconds. Unless
the actuator has been configured as a Billet Scanner, it will automatically
calculate and align with a hot region at the end of the scan.
The bar of LEDs shows the current position of the actuator within the set
scan range. The LED is normally green, flashing slowly. The flash rate
increases during movement and when the SPOT LED is switched on. The LED
goes yellow if the unit is under automatic control (e.g. during a Scan & Go),
and red under a fault condition.
The remote can be used to restore the factory settings of the Actuator.
Switch off the power to the actuator, and hold both Left and Right arrow
buttons down while switching the power on. Release the buttons when the
green LEDs on the body of the Actuator start to flash alternately.
Move right
Short Press - Move 1 step
Press & Hold - Move continuously
Short Press - Switch on LED
Press 3 Seconds - Scan & Go
Move left
Short Press - Move 1 step
Press & Hold - Move continuously