Ametek Land 808100, Installation Manual

Page: 11 / 16

7
SPOT Water Cooled Mountings
Installation Guide
3
Installing the SPOT Thermometer in the
Water Cooled Mounting
Note
The Water Cooled Mounting is supplied fitted with a cable gland for the
Power over Ethernet (PoE) cable, and a Blanking Plug fitted in the Analogue
Cable port. If you want to use an Analogue cable, you will need to replace
the Blanking Plug with a Large Connector Sealed Gland (M25) (Land Part
Nº 810481), available from Land Instruments International. Refer to
Section 3.1 in addition to the following instructions.
1) Fig. 3-1 shows a SPOT
Thermometer, with Water
Cooled Mounting and Power
over Ethernet (PoE) cable.
Fig. 3-1
Fig. 3-2
2) Unclip the fastener on the
Water Cooled Mounting and
open the hinged Back Cap
(Fig. 3-2).