Page 6
For technical questions, please call 1-888-866-5797.
Item 64001
Sa
F
ety
Opera
ti
O
n
Maintenance
Setup
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
General Operating instructions
powering Meter On and Off
1� Press to power Meter on�
2� Hold
c
to power Meter off�
Selecting units
Press and
c
at the same time to switch between measurement units�
Selecting reference point
Press
c
to change laser reference point between front,
center, and rear of Meter�
auto power-Off
If Meter is not used for approximately 5 minutes, it will
automatically power off to preserve battery power�
Measurement Operation
Single Measurement Mode
1� Press to power Meter on�
Meter automatically enters
single measurement mode�
2� Press again to turn laser on�
Laser On Icon flashes on Display�
3� Aim laser at target to be measured�
4� Press again to begin measuring�
5� Read measured distance on Display�
6� Repeat steps to take additional
measurements� Up to two
previous measurements are
held on the Auxiliary Display
until Meter is powered off�
continuous Measurement Mode
1� Press to power Meter on�
2� Hold for a few seconds to begin
continuous measurement�
3� Move laser between two points to be
measured and read measurement
from Display as it changes�
4� Press again to stop
measurement and turn laser off�
